A RS Range
Heat Regenerative Thermal Swing Adsorption Dryers
CompAir’s range of heat regenerative thermal swing adsorption dryers – with an operating pressure of 4 – 13 bar g – use the thermal swing adsorption method of drying compressed air. This method increases operating efficiency by reducing purge air consumption.
To reduce the amount of purge air required, heat is added to assist the process. Two heater assemblies are strategically placed in each dryer column to heat the purge air, optimizing regeneration. The heaters are switched on after the column has de-pressurised to additionally reduce energy consumption.
The combination of dry purge air and heat, uses less energy to remove the water from the saturated desiccant bed than is consumed by purge air alone.
Pre- and after- filter are included with the A RS range adsorption dryers from CompAir.
Energy saving dew point control and an advanced energy saving electronic control system are both optional extras with this range of adsorption dryers.
Key Benefits
- Increased operating efficiency
The thermal swing adsorption method increases operating efficiency by reducing purge air consumption. - High air quality
Delivered air quality is in accordance with ISO 8573-1 : 2010. - Consistent dew point performance
Continuous and consistent dew point performance are just two of the benefits realised with CompAir’s adsorption dryers, thanks to the snowstorm filling technique used to charge the drying chambers with absorbent desiccant material. - Low noise level
With low noise levels, the CompAir adsorption dryers are ideal for point of use applications as well as in a compressor room.
Technical Data
| Type** | Capacity* m3/min |
Dimensions mm (W x H x D) |
Inlet & Outlet Connection EN ISO 228-1 |
Design Pressure bar (g) |
Weight (kg) |
Pre-filter Type |
After-Filter Type |
||
| A040RS | 3.96 | 321 | 1578 | 717 | G 2″ | 10.5 | 150 | CF132G2″C | CF132G2″EHT |
| A080RS | 7.93 | 321 | 1578 | 947 | G 2″ | 10.5 | 245 | CF132G2″C | CF132G2″EHT |
| A120RS | 11.89 | 321 | 1578 | 1177 | G 2 1/2″ | 10.5 | 325 | CF240G21/2″C | CF240G21/2″EHT |
| A160RS | 15.86 | 321 | 1578 | 1407 | G 2 1/2″ | 10.5 | 440 | CF240G21/2″C | CF240G21/2″EHT |
| A190RS | 19.82 | 321 | 1578 | 1637 | G 2 1/2″ | 10.5 | 565 | CF240G21/2″C | CF240G21/2″EHT |
Electric connection 415 V / 3 +neutral / 50 − 60 Hz
*) Relating to ISO 7183, A: 1 bar(a), ambient temperature +25°C, inlet temperature + 35 °C, saturated, at 7 bar g and pressure dew point − 25 °C.
**) Pre- and after filter are not factory mounted
CompAir Modular System Adsorption Compressed Air Dryers Brochure | Request more information